Help Center

The TurboSwing has a tow rating of 600 pounds dry weight. We have already factored in the drag when considering this.

No, you would not have to reinforce your hull. The TurboSwing will be mounted on the transom; it is the strongest structure of the boat. The TurboSwing holders fit exactly on the motor bracket and will be, together with the motor, mounted on the transom using the same bolts. The holders are universal, therefore the holes in the holders match the holes in the motor bracket. All motors have the same brackets. The main bolts at the top of the motor bracket that are already present will be used. For reasons of stabilization, on both sides a 2nd hole will be drilled and a 2nd stabilization bolt installed in one of the 4 or 5 pre-drilled bolt holes. Always leave a minimum of 1, but preferably 2 holes between the main bolt and the stabilization bolt. Otherwise, no drilling or sawing is required at places that are unsuitable and that could weaken the structure of the boat. Reinforcement with epoxy and/or other structural reinforcement is unnecessary.

Yes, the turboswing will come with one pulley. Additional pulley's can be purchased if you wish to pull multiple tubes.

Installation takes roughly an hour, depending on your skill level. It is very easy and most people will be able to do it on their own.

The TurboSwing comes with two extra motor bracket bolts that can be used to mount the TurboSwing directly to the transom if it is not possible to use the motor bracket or if you do not wish to mount it using the motor bracket.

You can search for dealers near you on our Local Support page.

If instructions were not in your shipment you can find them online on our website under the installation tab or call us for us to email you a link to them.

Yes! We have had success when installing a TurboSwing with jack platesbefore. When installing with a jack plate it actually makes it easier to install. You won't have to drill through your transom but drill through the jack plate instead, or your jack plate may already have accommodating holes. You can also call or email for more dimensions as well to give you a better idea if it would work for your specific set up.

Yes it can!

For TurboSwing installation, we recommend using 3M™ Marine Adhesive Sealant Fast Cure 4200FC as it is tack free in 1 hour and can allow for disassembly if needed. It is a non-PVC, non-silicon sealant this is recommended as silicon base sealant can stain gel coat.

For the XXL you can measure the bar from the widest part of the bend to the widest part of the end on the other side and it should measure 46 7/8 inches across.

Our tubes are shipped from WOW directly, please call us to obtain an additional tracking number. Your tube should arrive 1-2 days after your TurboSwing.

We recommend the towing capacity to be 600 lbs dry weight.

Yes! We have had success when installing a TurboSwing with jack platesbefore. When installing with a jack plate it actually makes it easier to install. You won't have to drill through your transom but drill through the jack plate instead, or your jack plate may already have accommodating holes. You can also call or email for more dimensions as well to give you a better idea if it would work for your specific set up.

Yes, if you have a Johnson Outboard Motor you can still use our configurator by selecting the Engine Manufacturer as "Evinrude".

No, this listing for the Tube Holder is just for the Tube Holder.

600 dry weight

Opting for a larger size should be fine. Please use dimensions to confirm your setup is compatible with the larger size and other objects will not interfere with the swing such as ladders, power poles, decks, etc,. Installing a smaller size than ...

We consider several factors when sizing the TurboSwing®: the make, horsepower, and cowling size of your motor. If necessary, you may move up a size. However, due to possible contact between the TurboSwing and the motor, we do not recommend moving down...

Unfortunately, we do not recommend TurboSwing products with a Party Barge Pontoon. Near the engine mounts, there is a  lip/fin that causes a water spray into the boat. This spray may also spray onto the rope. In addition to the spray, the engines...

Yes, the turboswing warranty covers parts and workmanship for 5 years.

TurboSwing is backed by a 30 day return policy.

Please give us a call at 1-855-228-8726 to have our customer service representatives create you a RMA. Returns sent in without an RMA are likely to not be refunded.

Please give us a calll at 1-855-228-8726.

Our tubes are shipped from WOW directly, please call us to obtain an additional tracking number. Your tube should arrive 1-2 days after your TurboSwing.

Please confirm your email address is correct with your order, give us a call to get this updated.

You can purchase direclty from TS or your local dealer.

Our products are shipped from Knoxville, TN and take 1 to 5 days to arrive depending on your location.

Your email may have been entered incorrectly, for more information on tracking or further questions please give us a call, 877-778-6937.

Yes, we do ship internationally to North, Central, and South America. International customers are responsible for all duties, taxes, brokerage fees, and any other related import fees. For orders going to EMEA please contact Marine Accessories BV at +...

Maintenance is minimal. Corrosive substances, such as salt, chlorides and iron oxide, are found in the water. Clean off any deposits using a plastic brush (do not use a metal scouring pad), boat soap and water. For stubborn dirt and lime scale, use a waterline or hull cleaner. After cleaning or using the TurboSwing, rinse it off thoroughly with clean water.

Your boat's outboard motor also contains stainless steel parts and is therefore equipped with anodes for cathodic protection. Ensure that the anodes are always in good condition to avoid galvanic corrosion. The installation of the TurboSwing can lead to the sacrificial anodes shrinking more quickly, therefore, check them regularly. There is a hole at the base of the holders to which an additional anode can be attached if required. The anodes should be checked more regularly, or consideration should be given to installing more anodes, if the boat will be in salt water for a long time.

Yes. You can find them on our Parts catalog under Accessories